I have been able to confirm the tiboot3 keywriter implementation on an EVM. However, I'm looking to see if this is a process that can be completed once the device is in an HLOS state. I havent been ...

I've successfully configured the BQ76942 in my system and everything seems to be working fine. I've done this development using the EV2400. I would now like to OTP the part using the EV2400. I've ...

The following problems occur in the BQ34Z100 demo test. 1. During the discharge process at 0℃ 1C, the SoC jumps directly from 100% to 0%, and the capacity almost becomes 0. The parameters are as ...

We are designing and testing BQ40Z50 with a 4s34 configuration li-ion battery pack system. We wish to reconfigure BQ40Z50 using BQSTUDIO. The issue is we couldn't find out how to make BQSTUDIO talk to ...

the AMP IC's boost mode is "alway boost mode" Boost Voltage is 11V. During production, a defect often occurs in which the VBST output (internal Boost circuit) of the AMP IC does not output. Could it ...

Note - all references to issuing commands and displaying data refer to the use of BQStudio and an EV2400. Also just to provide context, I have a BQ27520EVM connected to a BQ41Z50EVM, and my ultimate ...

exactly same as here, but no way to complete the installation.I also tried to launch orLibraryDownload from the command line, just for test. Here is the result: then, nothing happens.

We use gmake tool to build our AM62Ax project in windows operation system, sometimes the compiler report error log as the screenshot show,but if we try to rebuild the ...

My customer has a question about SD pin. I would be grateful if you could advise. According to the LMH6601 datasheet, p. 20, 7.2.1 Shutdown Capability and Turn On/Off Behavior, If SD_Pin (5PIN) is not ...

Issue Description: The MRR code crashes when connecting the RADAR (AWR1843) with our ECU, which dumps multiple messages on the CAN bus. The RADAR's CAN is configured to receive classic CAN messages at ...

I am trying to use string concat , strcpy , strcmp function for example testData[10] = {'\x02', 'A', 'B', 'C','2', 'D','0','M','\x03'}; to concat this testData to a ...

Hi folks! I would like to use this part for it's GPIO/SPI CS expansion only and not use any of the inst amp side of the chip. It's easier and faster than implementing a small micro... Can you confirm ...