We are designing and testing BQ40Z50 with a 4s34 configuration li-ion battery pack system. We wish to reconfigure BQ40Z50 using BQSTUDIO. The issue is we couldn't find out how to make BQSTUDIO talk to ...

Note - all references to issuing commands and displaying data refer to the use of BQStudio and an EV2400. Also just to provide context, I have a BQ27520EVM connected to a BQ41Z50EVM, and my ultimate ...

I am trying to use string concat , strcpy , strcmp function for example testData[10] = {'\x02', 'A', 'B', 'C','2', 'D','0','M','\x03'}; to concat this testData to a ...

We are raising a query regarding CCS GUI Composer. After login into CCS GUI composer, We are trying to create a project and establish connection between the experiment kit(TMS320F28335) and System(PC) ...

the AMP IC's boost mode is "alway boost mode" Boost Voltage is 11V. During production, a defect often occurs in which the VBST output (internal Boost circuit) of the AMP IC does not output. Could it ...

Hi folks! I would like to use this part for it's GPIO/SPI CS expansion only and not use any of the inst amp side of the chip. It's easier and faster than implementing a small micro... Can you confirm ...

My customer has a question about SD pin. I would be grateful if you could advise. According to the LMH6601 datasheet, p. 20, 7.2.1 Shutdown Capability and Turn On/Off Behavior, If SD_Pin (5PIN) is not ...

Uploads a binary file to the Flash memory, via SPI, then clears the flag and resets Makes the jump to the aplication uint32_t transferAddress; // Address that is ...

I am using PIC32MZ2064DAS169i micro controller with DP83848 PHY. I have interfaced the DP83848 PHY driver library in MPLAB version 6.20 harmony library. When i am ...

We use your company's TPS27100 chip to test the load capacity with the output connected to the load. When ILIM is connected to the ground, the working environment temperature is 25 degrees Celsius and ...

Issue Description: The MRR code crashes when connecting the RADAR (AWR1843) with our ECU, which dumps multiple messages on the CAN bus. The RADAR's CAN is configured to receive classic CAN messages at ...

I want to use the DTC function of the UCD7138, which is controlled by the UCD3138A, so I need to customize the UCD3138FW_LLC firmware. I would like to add an interrupt process when the CIMINT_ALL_DTC ...